A unit without heat in Troy? Emergency furnace service is available. Call 844-MY-JOCKEY
Troy Homes, Rowhouses And Rentals

Furnace Repair in Troy, NY for Every Unit Under the Roof

Furnace repair in Troy, NY often means two furnaces under one roof, one for the downstairs flat and one for the upstairs. We diagnose each unit on its own, work around tenants and landlords, and write up a flat rate for each furnace before anyone picks up a tool.

EveryMajor Brand Repaired
FlatRate Before Work
90 DayRepair Warranty
4.9327 Google Reviews
Two Units, Two Furnaces Unit By Unit
Each UnitDiagnosed on its own
Tenant AccessSet up with the owner
PriceFlat rate, in writing
PartsCommon ones on the truck
Home Depot Install Partner
Google Guaranteed
Licensed & Insured
Bryant & Carrier Dealer
4.9 Stars, 327 Google Reviews
How Troy Houses Heat

Two Flats,
One Basement

Troy has more two-family houses and small apartment buildings than any other kind of housing, and many of them heat each apartment with its own furnace. In a stacked two-family with forced air, each flat usually has its own furnace, its own thermostat, and often its own gas meter. The furnaces tend to sit side by side in the same basement.

That setup changes a repair call. The cold unit might be upstairs while the broken furnace is the one nobody looks at. Ducts for the top flat climb long runs through old walls. A landlord may live across the river while the tenant is the one standing in the cold. So we start every Troy job by matching each furnace to its unit and its thermostat, then test the one that failed.

We repair furnaces in single-family houses here too, from downtown rowhouses to homes up on the Eastside. If you want the full list of what we fix in the city, our Troy HVAC services page covers heating, cooling, and water heaters.

What we check first in a Troy multi-unit

Which furnace feeds which unit. Labels wear off. We trace the thermostat wire before we touch anything.
The shared chimney. Older furnaces often vent into one masonry flue. A blockage there can shut down both.
Gas and power to each unit. Separate meters and breakers mean one unit can lose supply on its own.
Radiators instead of vents? That is a boiler, and our boiler repair team handles it.
Call 844-MY-JOCKEY
Before You Call

Who Is Calling,
and What Went Cold?

Pick two answers. You get a short list of what to tell us on the phone and what the pattern usually points to, so the technician arrives with the right plan.

Step 1

I am the

Step 2

What has no heat?

Landlord or manager, one unit cold

Tell us when you call
  1. The property address and the unit numbers that are cold.
  2. Tenant names and phone numbers, or a note that you will meet us there.
  3. Where the furnaces are and how we get in, including a locked basement door and who can open it.
  4. Who approves the flat-rate price, and the best number to reach them during the visit.
What it usually points to

When one unit is cold and the other is fine, the problem is usually inside that unit's own system: its furnace, thermostat, or wiring. Failed igniters, dirty flame sensors, tripped pressure switches, and clogged filters top the list.

Call today. One cold unit in January should not wait for next week.

Call 844-MY-JOCKEY

Gas smell or a carbon monoxide alarm in any unit? Get everyone out of the whole building, not just the one flat. Call 911 or National Grid from outside. We fix the furnace after the building is safe.

Signs It Needs Repair

Six Furnace Problems We Fix in Troy Basements

Each one has a common cause in older city housing. Catch it early and it is usually a part, not a new furnace.

01

Blowing cold air

The blower runs but the burners never light, or light and drop out a few seconds later.

Often: a cracked igniter or a flame sensor coated with grime.
02

Starting and stopping

Short runs all day, and a unit that never quite warms up.

Often: overheating on a choked filter or long, pinched duct runs to the upper flat.
03

Rust or water at the base

Orange flakes under the burners, or a puddle around a high-efficiency unit.

Often: a damp basement, or a cracked condensate trap or failed pump.
04

Thermostat on, furnace silent

No hum, no click, nothing, even with fresh batteries and the switch on.

Often: a blown low-voltage fuse, a failed board, or a broken thermostat wire in an old wall.
05

A lazy yellow flame

Burner flames that look soft and yellow instead of crisp and blue, or soot near the burners.

Often: rusted burners or a venting problem. Turn it off and call.
06

Banging or squealing

A boom at startup, or a squeal that the tenant upstairs hears through the floor.

Often: delayed ignition from dirty burners, or a worn blower or inducer motor.
Damp Basements

What Wet Air
Does to a Furnace

Plenty of Troy basements stay damp, especially in older houses with stone or brick foundations on the low ground near the Hudson. A furnace that sits in wet air for years wears in a predictable way, and the trouble usually starts at the bottom of the cabinet.

Rust flakes off the burners and falls into the flame path, so the flame burns poorly and can roll out and trip a safety switch. Wire ends and switch terminals corrode until the furnace quits on and off with no clear pattern. That kind of intermittent no-heat call is one of the most common we see in older city basements, and it is fixable when we find it early.

We clean and test, not just resetBurners pulled and cleaned, terminals checked, and safety switches tested before the furnace goes back in service.
Keep water away from the cabinetA furnace on a raised pad, a working floor drain, and a dehumidifier in summer all slow the rust down.
Look again after a wet springIf the basement took on water, have the furnace checked before you need heat in the fall.
The Repair Visit

Three Steps, Even With Tenants in the Middle

Owner-occupied or rented, the order is the same. The only difference is who we keep in the loop.

1

We Set Up Access

We take the first open slot, and when the schedule allows that is the same day. If tenants live there, we confirm who lets us in and who approves the price before the truck leaves.

2

We Diagnose Unit by Unit

The technician matches each furnace to its thermostat, then runs the failed one through its full startup: power, inducer, pressure switch, ignition, flame sensing, blower, and venting.

3

Flat Rate, Fix, Report

You approve one written price before work starts. We make the repair, test full heating cycles and the safety controls, and tell the owner what we found, even when the owner is not on site.

Fix It Or Replace It

Two Furnaces Rarely Wear Out Together

In a two-family, one furnace may be decades old while the other was swapped a few winters ago. We price the repair on the one that failed and tell you plainly if that money would be better spent on a replacement.

Owners of multi-unit buildings often plan replacements one unit at a time. For the unit that is done, we put in a Bryant or Carrier furnace, sort out which rebates apply, and can set up financing.

Furnace Installation in Troy
Cracked Heat ExchangerA safety failure. On an older furnace, replacement is usually the honest answer.
Same Unit, Every WinterOne furnace that keeps needing a new part while its neighbor runs fine.
Parts No Longer MadeOn an older furnace, the inducer or control we need may be back-ordered or no longer made.
Upstairs Never WarmsA furnace too small or too tired to push heat up two floors of ductwork.
What Sets The Price

What Drives the Cost of a Troy Furnace Repair

Each furnace in the building gets its own diagnosis and its own written flat rate before any work. These four things move that number.

The part that failed

Cleaning a flame sensor is a small job. A new inducer or control board is a bigger job, and on a basement furnace that sat in damp air the corroded wiring often comes with it.

How many units

Each furnace is diagnosed and priced on its own. Two failures in one building means two line items.

Getting to the furnace

Steep rowhouse stairs, low beams, and furnaces boxed into tight corners add labor.

Venting and safety

A blocked chimney flue or rusted burners sometimes have to be fixed before the furnace can run safely.

Licensed and insured matters when the furnace sits under someone else's apartment. On top of that we are Google Guaranteed, a Home Depot Authorized Installation Partner, and a Bryant and Carrier dealer, and our technicians work on every major brand. Our main furnace repair page lists every repair we handle.

Rensselaer CountyTroy, east bank of the Hudson
Getting To You

From Our Shop
to Your Basement

Our trucks leave the shop on Route 9 in Gansevoort, run down the Northway to Exit 7, and take Route 7 across the Collar City Bridge onto Hoosick Street. That puts us in the middle of the city, ready to work north, south, or up the hill.

If the furnace blower also runs your central air, our AC repair in Troy covers the cooling side.

Downtown and Washington ParkBrick rowhouses, tight basements
LansingburghNorth end, many two-family homes
Eastside and SycawayHillside homes and foursquares
South TroyOlder houses on the low ground by the river
Troy Furnace Questions

What Troy Owners and Landlords Ask Us

Often, yes. We diagnose each furnace on its own and give you a separate written price for each one. If both need parts we carry on the truck, we can usually handle both on the same visit. If one needs a part ordered, we get the other unit warm first.
Yes. Send us the tenant's contact details, the way into the basement, and the name of whoever signs off on the price. The technician calls that person with the diagnosis and the flat rate before any work starts, then reports what was done when the job is finished.
Yes. Emergency service is available when the office is closed. The office is open weekdays from 7 AM to 7 PM and Saturdays from 8 AM to 5 PM, and Sundays are by appointment. When every unit goes cold at once, tell us on the call. It often points to something the furnaces share, like the gas supply, basement power, or a common chimney flue, and we check that first.
Damp air. Many older basements in the city hold moisture, and a furnace sitting in it rusts from the burners down. Keep the area around the furnace dry and off a wet floor. If you see orange flakes under the cabinet, or the furnace shuts off for no clear reason, have the burners and safety switches checked.
Change filters on a schedule, since tenants rarely do, and book a furnace tune-up for each unit in the fall. On that fall visit we clean the flame sensor, test the igniter, and listen to the motors while a tired part is still a quick swap. Doing every furnace in the building on one visit saves a second trip.
Cold Unit In Troy?

One Call Covers Every Unit

Tell us which units are cold and who will let us in. We set the visit around whoever can open the basement, test each furnace that is down, and send the owner a written price before we start.

My Jockey technician going over furnace repair details on a clipboard with a homeowner at the front door
Free Quote, No Obligation

Tell Us Which
Unit Is Cold

Send the Troy address, which unit is cold, and whether the furnace clicks, hums, or stays silent when the heat is turned up. If tenants live there, add who can let us in. We call back with the next open slot and confirm who will meet the technician.

Landlords managing several units can email [email protected] or reach the office from the contact page.

Same-Day When OpenRepairs booked into the first available slot
Price In WritingFlat rate approved by the owner before work starts
90-Day WarrantyOn every furnace repair we make
No Heat Now?
Call 844-MY-JOCKEY

Schedule Your Furnace Repair

Troy service, flat-rate pricing, no obligation.